|Name||USB-SD Card Mass-Storage Design|
|Description||This reference design demonstrate the USB based mass storage application over Altera's MAX 10 Evaluation Kit using SLS MAX 10 Evaluation Kit Add On Board. The Add On board is having both USB 2.0 and micro SD Card interface. The Add On board plugs on Arduino and GPIO connector of MAX 10 Evaluation Kit and MAX 10 runs the mass storage design. This design used the SLS USB2.0 Device and SD Host Controller IP Cores along with Mass storage protocol. After programming the kit, when the USB cable connects to the PC, it appears as a mass storage drive in the PC based on the micro SD card size.|
|Development Kit||MAX10 Evaluation Kit Add On|
|Installation Package|| Download|
Note: After downloading the design example, you must prepare the design template. The file you downloaded is of the form of a <project>.par file which contains a compressed version of your design files (similar to a .qar file) and metadata describing the project. The combination of this information is what constitutes a <project>.par file. In releases 16.0 or newer, you can simply double click on the <project>.par file and Quartus will launch that project.
Browse to the <project>.par file you downloaded, click next, followed by Finish, and your design template will be installed and displayed in the Project Navigator pane in Quartus.
Note: When a design is stored in the Design Store as a design template, it has been previously regression tested against the stated version of Quartus software. The regression ensures the design template passes analysis/synthesis/fitting/assembly steps in the Quartus design flow.
At the command-line, type the following command:
Once the process completes, then type:
|Total Downloads||22 (From 22 Dec 2016 to 27 Apr 2017)|
|Quartus II Version||Download Quartus II v16.0|
Last updated on Dec. 22, 2016, 9:19 a.m.